SAM-MT 100 is an SNMP enabled DVB-H monitoring probe. This rack mountable 19" device (1 HU) is suited for both monitoring DVB-H on-site (directly at the sender location, monitoring via ASI or SPI interface) and for monitoring DVB-H off-site (remotely in the field, monitoring via RF de-modulator).
|
Features |
 |
- Monitoring of parameters on all DVB-H layers, i.e.
- RF layer
- Transport/MPEG2 layer
- MPE layer
- IP layer
- RTP layer
- FLUTE layer
- ESG layer
- Audio/Video layer
|
- Support of SNMPv2 GET, SET and TRAP
- use on-site directly at the sender via ASI or SPI interface
- use off-site in the field via RF de-modulator
- comfortable configuration via RDP (Remote Desktop) and SNMP
- beside support for DVB-H also support for DVB-T, DVB-S and DVB-S2
- automatic TS snapshot for later detail analysis of problems
- bandwidth monitoring per service
- highly configurable and customizable
- on request a customer specific MIB can be provided for a
seamless integration into existing monitoring backends
|
|
Technical Characteristics |
|
|
Connectors |
|
| RF: |
1 x RF-In device connected via USB 2.0 |
| ASI: |
1 x ASI-In 75 Ω BNC |
| USB: |
3 x USB 2.0 |
| Power: |
1 x 220V AC |
| Network: |
10, 100, 1000 MBit/s Ethernet |
|
|
RF |
|
| UHF Range: |
474 to 860 MHz |
| Channel Bandwidth: |
5, 6, 7 and 8 MHz |
| FFT Size: |
2k, 4k, 8k |
| Reception Modes: |
single, diversity |
Note:
SAM-MT 100 can use a professional RF tuner as well as budget RF tuners based on DiBcom DiB7000PC chipset |
|
|
ASI / SPI |
|
| Bit Rate: |
0..214 Mbit/s |
| Packet Size: |
188 or 204 Bytes |
|
|
Remote Administration |
|
| Basic Setup: |
RDP (Remote Desktop) |
| Monitoring Parameters: |
both SNMP or RDP |
| Monitoring Thresholds: |
both SNMP or RDP |
|
|
System Parameters |
|
| Log File Storage: |
50 GB |
| Snapshot Storage: |
150 GB |
| Simultan. MPE-FEC: |
8 (at least) |
Note:
SAM-MT 100 can be equipped with more storage and additional processor cores on request. |
|
|
Failsafe Measurements |
|
| Redundant NIC: |
yes |
| Redundant TRAP Destination: |
yes |
| Application Heartbeat: |
yes |
|
|
Dimensions |
|
| Dimension: |
480 x 45 x 600 mm (19", 1HU) |
| Weight: |
10kg |
|
|
System Overview |
|
|
Monitoring Capabilities |
|
The SAM-MT 100 is optimally suited for both on-site monitoring via its ASI or SPI interface as well as for off-site monitoring via its RF tuner.
Any number of remote probes ( SAM-MT 100) can be installed country wide for building a monitoring network par excellence.
The monitoring solution allows monitoring of the entire transport stream in realtime at all terrestrial bandwidths.
Some examples of the performed measurements in the different layers are:
| RF layer: |
Signal Strength, SNR, MER, BER after Viterbi and PER |
| Transport/MPEG-2 layer: |
all DVB-H relevant parameters of ETSI TR 101 290, separated by Prio 1/2/3... |
| MPE layer: |
IP-PER, Time Slice Jitter, MFER, MPE-FEC of all services inside the TS... |
| IP/RTP layer: |
RTP sequence counter, IP data rates, IP/port missing... |
| ESG layer: |
bootstrap + all container contents of all ESGs inside the TS simultaneously, independent on whether they are encoded according IPDC or OMA BCAST standard. Update Cycles Times... |
| General: |
TS snapshots get created automatically if configurable error thresholds are exceeded for later detail problem analysis |
All parameters get monitored simultaneously in realtime!
|
Ordering Information |
|
For more information please contact decontis.
Click here
|
